кроем крышу дома
однокомнатные квартиры вторичка недорого москва
Be convinced that the fuel tank is filled a maximum on 2/3, otherwise gasoline will flow out! Cast away a floor covering of a luggage carrier. Unscrew a black cover. Disconnect многоштырьковый a socket. Disconnect рециркуляционный the pipeline. Disconnect submitting pipeline. Unscrew synthetic накидную a nut. More often they sit very strongly. Therefore establish on a nut edge the most stupid screw-driver, and a lung hammer blows on the screw-driver handle ослабьте nut fastening. If it is necessary, knock on different edges. Now it is possible to pull a little upwards a deaf flange of a fuel tank. Loosen the on an inside of a deaf flange tightening a collar рециркуляционного the pipeline also pull together a hose downwards. Take out a socket of a fuel tank. Establish a special key 3307 on an internal detail of the case of an inlet collector. Turn a little to the left against the stop an internal detail of the case of an inlet collector. Take out the pump with an internal detail and together with a deaf flange from a fuel tank. Mark/remember assembly position of the pump, hoses, wires and sheaves of wires as details at installation should be mounted precisely. After unscrewing of the delivery pipeline (assembly position) the pump can be dismantled from an internal detail of the case of an inlet collector. It becomes on a miscellaneous depending on the pump version: The pump of 60 mm: turn to the left a sieve under an internal detail of the case of an inlet collector, take out the pump. At installation the nouse sideways on the pump should be pushed in a groove. Pay attention to a lining. The pump of 40 mm: compress deblocking collar above on an internal detail of the case of an inlet collector, take out the pump. At installation the pump can be inserted only in one position. Installation: a hose mount between the pump and a deaf flange how it is shown in drawings. The pump and a deaf flange should be in correct position rather each other. If all is collected correctly the pump can be mounted again in an external detail of the case of an inlet collector in a fuel tank. It is necessary to pay attention: the mark in an external detail should stand opposite risks on an internal detail. Again screw up an internal detail a key 3307, establish other details. Assembly position of a deaf flange: the arrow on a flange should be opposite to a mark in a fuel tank.